| BACHMANN 44 TON POWER TRUCK MODIFICATIONS Page 3. |
| Photo 1 |
| ---- ASSEMBLE THE LASER CUT MOTOR MOUNTS ---- |
| We recommend using Ambroid's "PRO-WELD" plastic solvent cement for bonding the acrylic parts. Satellite City's "Hot Stuff" Super 'T' and NCF 'Mild' Accelerator is recommended for bonding non-plastic and dis-similar materials. As always, use extreme care and safety with all glues, cements, paints and power and hand tools!!! |
| Photo 1 shows the 1/32" acrylic parts sheet. Along with the 1/16" thick acrylic Motor Mount "Yokes" shown in Photo 2, you will have the parts needed for Step 1, Assembling The Lower Motor Mount(s). Locate the Bottom Plate and Centering Plate as shown in Photo 3 and glue together. Locate the Lower Motor Mount Yoke and the 1/32" thick Backing Plate, assemble into slots in Bottom Plate and cement in place as shown in Photos 3 and 4. |
| Using a Motor Tool & Cut-Off Disc, trim two the Bachmann Screws so that they are approximately 1/8" long as shown in Photo 5. As long as you drilled the holes in the Frame deep enough, the screws will snuggle down to secure the Bottom Plate to the Frame. If not, use a # 54 drill to deepen the holes until proper fit is acquired. Place the Lower Motor Mount Assembly on the Truck Frame as shown in Photos 5 and 6. Note that the tab on the Bottom Plate aligns with the cut-out in the Truck Frame as indicated by the "Pointer" in Photo 6. |
|
 |
| Photo 4 |
 |
| Photo 5 |
 |
| Photo 6 |
 |
 |
| Photo 3 |
 |
| Photo 2 |
| Wear Eye Protection and practice good safety when using a Motor Tool. |